CONFIG
    // --------------------------------------------------
    // Display Configuration
    // EK79007 LCD panel (1024x600) connected via MIPI-DSI
    // --------------------------------------------------
    DISPLAY_DRIVER EK79007
    DISPLAY_BUS DSI
    DISPLAY_W 1024
    DISPLAY_H 600
    DISPLAY_DSI_LANES 2           ' Number of DSI data lanes
    DISPLAY_DSI_LANE_RATE 1000    ' Data rate per lane (Mbps)
    DISPLAY_RST 33                ' LCD hardware reset pin
    DISPLAY_BL 32                 ' Backlight brightness control (PWM)
    DISPLAY_BL_PWR 31             ' Backlight power enable (must be enabled)
    DISPLAY_BL_ACTIVE_LOW 0       ' Backlight is active-high
    DISPLAY_ROTATION 0

    // --------------------------------------------------
    // Audio Configuration
    // ES8311 audio codec connected through I2C and I2S
    // --------------------------------------------------
    AUDIO_OUT CODEC
    AUDIO_IN CODEC
    CODEC ES8311
    CODEC_I2C 0
    CODEC_ADDR 0x18

    // Shared I2C bus for codec and touch controller
    I2C0_SDA 7
    I2C0_SCL 8

    // I2S interface between ESP32 and codec
    I2S_MCLK 13
    I2S_BCLK 12
    I2S_WS 10
    I2S_DOUT 9
    I2S_DIN 11

    // Power amplifier control
    CODEC_PA_PIN 53
    CODEC_PA_ACTIVE_LOW 0

    // --------------------------------------------------
    // Touch Screen Configuration
    // GT911 capacitive touch controller
    // Shares I2C bus with the audio codec
    // --------------------------------------------------
    TOUCH_DRIVER GT911
    TOUCH_I2C 0
    TOUCH_RST 23                  ' Touch controller hardware reset
    TOUCH_INT -1                  ' Polling mode (no interrupt pin used)
    TOUCH_ADDR 0x5D
    TOUCH_MIRROR_X 1
    TOUCH_MIRROR_Y 1

END_CONFIG

// --------------------------------------------------
// Runtime Initialization
// --------------------------------------------------
DISPLAY_INIT

// Rotate display to match panel orientation
DISPLAY_ROTATE(180)

// Set display brightness (0-100%)
DISPLAY_BRIGHTNESS(0)

// Set audio output volume (0-100%)
AUDIO_VOLUME(50)

WHILE 1
    PAUSE 10
WEND