Test: ESP32 enclosure 60×40 with mounting posts
Test post for the new 3D models section.
A simple enclosure for an ESP32 dev board: 2 mm walls, a 2 mm base and two 5×5 mm posts for M2 screws. A 20 mm calibration cube in 3MF is attached as well.
Prints without supports.
- For which board
- ESP32-DevKitC
- Material
- PETG
- Layer height, mm
- 0.2
- Infill, %
- 20
- Supports
- No
- Print time
- 1 h 40 min
- License
- CC-BY-4.0
1
0 replies